Kitchen Sink Accessories
- Straight rim integral.
- Lever wasted, 1 ½” and 2″.
- 2A. Removable basket strainer for lever waste.
- Rear overflow connected to lever waste.
- Replacement basket waste (1 ½” stainless steel).
- Tail piece (brass or chrome plated) 1 ½” or 2″.
- 1 ½” continuous waste assembly, either brass or chrome plated.
- Combination wall and deck faucets on 8″ centers (others available).
- Spray faucet (wall type).
- Spray faucet (deck type).
- Spray faucet
- Funnel shaped gusset in lieu of standard.
- legs: 1 5/8″ O.D., 16 gauge 304 S/S.
- Cross bracing:
- Galvanized – 1″ x 16 ga.; 1 ¼” x 16 ga.; 1 5/8″ x 16 ga. S/S – 1″ x 16 ga.; 1 ¼” x 16 ga. 1 5/8″ x 16 g
- Adjustable S/S bullet foot, or S/S flange foot in lieu of standard.
- Shelving under drainboard available in either 18 ga., 16 ga. or 14 ga. galvanized or stainless steel. (When removable shelving is wanted, add “cross bracing”).
- 15A. Louvered (slotted) shelves.
- Return splash
- Extended faucet ledge welded to splash.
- Welding roll integral into splash.
- Corner turns
- Mitres
- Column cut outs.
- Field joints prepared for welding by others; or bolted type.
- Overflow compartment (6″ wide) with removable perforated basket (overall size of sink to remain the same; each compartment to be shortened equally; available in either 16 ga. or 14 fa. S/S for MKE 716 models).
- Varied compartment depths – “Two different depths” (available in either 16 ga. or 14 ga. S/S for MKE 716 models).
- Provision for “Pot N’ Pan” washing (can be supplied only with minimum 16″ depth sink).
- Removable perforated S/S false bottom.
- Removable S/S compartment cover.
- Rack guides – removable S/S for 1, 2 or 3 compartments
- Scrap hole without rubber scrap back.
- Stainless steel scrap chute (6″ diameter, “V” edge, 3″ deep)
- Garbage disposal note (3 ½”) disposal adapt weld (adaptor by others)
- Disposer cone welded to top (cone by others).
- Provisions for mounting disposer control.
- Undercounter dishwasher mounting provisions.
- Booster slid mounting
- Undercoating (not shown).
- Marine edge (in lieu of standard roll).
- Provision for sink heater
Note “A” For all drainboard sizes larger than 48″, see Dishtables
Note “B” Extra partition to make 4th compartment (overall length of sink remains the same), available in either 16 ga. or 14 ga. S/S for MKE 716 models.